Article Link
Collect
Submit Manuscript
Show Outline
Outline
Abstract
Keywords
References
Show full outline
Hide outline
Research Article

Impacts of uneven surface heating of an ideal street canyon on airflows and indoor ventilation: Numerical study using OpenFOAM coupled with EnergyPlus

Yuya XiongHong Chen()
School of Architecture and Urban Planning, Huazhong University of Science and Technology, Wuhan, Hubei, 430000, China
Show Author Information

Abstract

In the daytime, building facades and ground surfaces are heated by solar radiation, and the resulting buoyancy can change the flow field inside street canyons. In this study, the impacts of uneven and time-varying heating of surfaces inside an ideal urban street canyon (aspect ratio = 1) on single-sided indoor natural ventilation are analyzed. This work introduces a methodology for a numerical approach based on the coupling between a computational fluid dynamics (CFD) model and an energy balance model. First, EnergyPlus is employed to calculate the time-varying and uneven surface heating. Simulations are performed at four typical study times (05:00, 09:00, 15:00, 20:00) during a hot summer day (July 15) in Wuhan, China. Second, the surface temperature results are transferred to OpenFOAM for CFD simulation. Two inlet wind velocities (Uref) are investigated. The results show that for a relatively strong ambient wind (Uref = 3 m/s), the buoyancy caused by surface heating does not significantly change the airflow structures and indoor ventilation compared with those in the isothermal case. However, for a weak ambient wind (Uref = 0.5 m/s), the airflow structures inside the street canyon vary with the time of day. Moreover, the average air exchange rate (ACH) differs by −25.0% to 15.9% compared with that in the isothermal case, and the ACH of a single room increases by up to 2710%. The results indicate that the surface-heating-induced buoyancy is nonnegligible and should be carefully investigated, especially for weak ambient winds.

References

 

Ai ZT, Mak CM (2017). CFD simulation of flow in a long street canyon under a perpendicular wind direction: Evaluation of three com­putational settings. Building and Environment, 114: 293–306.

 

Ai ZT, Mak CM (2018). Wind-induced single-sided natural ventilation in buildings near a long street canyon: CFD evaluation of street configuration and envelope design. Journal of Wind Engineering and Industrial Aerodynamics, 172: 96–106.

 

Allegrini J, Dorer V, Carmeliet J (2013). Wind tunnel measurements of buoyant flows in street canyons. Building and Environment, 59: 315–326.

 

Allegrini J, Dorer V, Carmeliet J (2014). Buoyant flows in street canyons: Validation of CFD simulations with wind tunnel measurements. Building and Environment, 72: 63–74.

 

Allegrini J, Carmeliet J (2018). Simulations of local heat Islands in Zürich with coupled CFD and building energy models. Urban Climate, 24: 340–359.

 

Athamena K, Sini J-F, Rosant J-M, et al. (2018a). Numerical coupling model to compute the microclimate parameters inside a street canyon. Part Ⅰ: Methodology and experimental validation of surface temperature. Solar Energy, 174: 1237–1251.

 

Athamena K, Sini J-F, Rosant J-M, et al. (2018b). Numerical coupling model to compute the microclimate parameters inside a street canyon. Part Ⅱ: Experimental validation of air temperature and airflow. Solar Energy, 170: 470–485.

 

Baik J-J, Kim J-J (1999). A numerical study of flow and pollutant dis­persion characteristics in urban street canyons. Journal of Applied Meteorology, 38: 1576–1589.

 

Baik J-J, Kang Y-S, Kim J-J (2007). Modeling reactive pollutant dispersion in an urban street canyon. Atmospheric Environment, 41: 934–949.

 

Battista G, Mauri L (2016). Numerical study of buoyant flows in street canyon caused by ground and building heating. Energy Procedia, 101: 1018–1025.

 

Bottillo S, de Lieto Vollaro A, Galli G, et al. (2014). Fluid dynamic and heat transfer parameters in an urban canyon. Solar Energy, 99: 1–10.

 

Hang J, Lin M, Wong DC, et al. (2016). On the influence of viaduct and ground heating on pollutant dispersion in 2D street canyons and toward single-sided ventilated buildings. Atmospheric Pollution Research, 7: 817–832.

 

Hang J, Buccolieri R, Yang X, et al. (2019). Impact of indoor-outdoor temperature differences on dispersion of gaseous pollutant and particles in idealized street canyons with and without viaduct settings. Building Simulation, 12: 285–297.

 

Hosseini SH, Ghobadi P, Ahmadi T, et al. (2017). Numerical investigation of roof heating impacts on thermal comfort and air quality in urban canyons. Applied Thermal Engineering, 123: 310–326.

 

Huang Y, He W, Kim C-N (2015). Impacts of shape and height of upstream roof on airflow and pollutant dispersion inside an urban street canyon. Environmental Science and Pollution Research, 22: 2117–2137.

 

Jiang Y, Chen Q (2001). Study of natural ventilation in buildings by large eddy simulation. Journal of Wind Engineering and Industrial Aerodynamics, 89: 1155–1178.

 

Jiang Y, Alexander D, Jenkins H, et al. (2003). Natural ventilation in buildings: measurement in a wind tunnel and numerical simulation with large-eddy simulation. Journal of Wind Engineering and Industrial Aerodynamics, 91: 331–353.

 

Jiang G, Hu T, Yang H (2019). Effects of ground heating on ventilation and pollutant transport in three-dimensional urban street canyons with unit aspect ratio. Atmosphere, 10: 286.

 

Kim J-J, Baik J-J (2001). Urban street-canyon flows with bottom heating. Atmospheric Environment, 35: 3395–3404.

 

Krayenhoff ES, Voogt JA (2007). A microscale three-dimensional urban energy balance model for studying surface temperatures. Boundary-Layer Meteorology, 123: 433–461.

 

Leitl BM, Meroney RN (1997). Car exhaust dispersion in a street canyon. Numerical critique of a wind tunnel experiment. Journal of Wind Engineering and Industrial Aerodynamics, 67–68: 293–304.

 

Li X, Liu C, Leung D, et al. (2006). Recent progress in CFD modelling of wind field and pollutant transport in street canyons. Atmospheric Environment, 40: 5640–5658.

 

Mei S-J, Liu C-W, Liu D, et al. (2016). Fluid mechanical dispersion of airborne pollutants inside urban street canyons subjecting to multi-component ventilation and unstable thermal stratifications. Science of the Total Environment, 565: 1102–1115.

 

Nazarian N, Kleissl J (2016). Realistic solar heating in urban areas: Air exchange and street-canyon ventilation. Building and Environment, 95: 75–93.

 

Nazarian N, Fan J, Sin T, et al. (2017). Predicting outdoor thermal comfort in urban environments: a 3D numerical model for standard effective temperature. Urban Climate, 20: 251–267.

 

Oke TR (1988). Street design and urban canopy layer climate. Energy and Buildings, 11: 103–113.

 

Omrani S, Garcia-Hansen V, Capra BR, et al. (2017). Effect of natural ventilation mode on thermal comfort and ventilation performance: Full-scale measurement. Energy and Buildings, 156: 1–16.

 

Peng Y, Ma X, Zhao F, et al. (2017). Wind driven natural ventilation and pollutant dispersion in the dense street canyons: Wind Opening Percentage and its effects. Procedia Engineering, 205: 415–422.

 

Ramponi R, Blocken B (2012). CFD simulation of cross-ventilation for a generic isolated building: Impact of computational parameters. Building and Environment, 53: 34–48.

 

Rodríguez-Vázquez M, Hernández-Pérez I, Xamán J, et al. (2020). Coupling building energy simulation and computational fluid dynamics: an overview. Journal of Building Physics, 44: 137–180.

 

Sacht H, Bragança L, Almeida M, et al. (2016). Study of natural ventilation in wind tunnels and influence of the position of ventilation modules and types of grids on a modular facade system. Energy Procedia, 96: 953–964.

 

Sini J-F, Anquetin S, Mestayer PG (1996). Pollutant dispersion and thermal effects in urban street canyons. Atmospheric Environment, 30: 2659–2677.

 

Tan Z, Dong J, Xiao Y, et al. (2015). A numerical study of diurnally varying surface temperature on flow patterns and pollutant dispersion in street canyons. Atmospheric Environment, 104: 217–227.

 

van Hooff T, Blocken B (2013). CFD evaluation of natural ventilation of indoor environments by the concentration decay method: CO2 gas dispersion from a semi-enclosed stadium. Building and Environment, 61: 1–17.

 

van Hooff T, Blocken B, Tominaga Y (2017). On the accuracy of CFD simulations of cross-ventilation flows for a generic isolated building: Comparison of RANS, LES and experiments. Building and Environment, 114: 148–165.

 

Wang L, Wang J, Zhao B, et al. (2005). Characteristics of airflow and vehicular exhaust pollutant dispersion in non-isolated urban street canyons. Research of Environmental Sciences, 18(6): 18–22. (in Chinese)

 

Wang J, Zhang T, Wang S, et al. (2018). Numerical investigation of single-sided natural ventilation driven by buoyancy and wind through variable window configurations. Energy and Buildings, 168: 147–164.

 

Xie X, Liu C-H, Leung DYC (2007). Impact of building facades and ground heating on wind flow and pollutant transport in street canyons. Atmospheric Environment, 41: 9030–9049.

 

Yassin MF (2013). Numerical modeling on air quality in an urban environment with changes of the aspect ratio and wind direction. Environmental Science and Pollution Research, 20: 3975–3988.

 

Yoshie R, Jiang G, Shirasawa T, et al. (2011). CFD simulations of gas dispersion around high-rise building in non-isothermal boundary layer. Journal of Wind Engineering and Industrial Aerodynamics, 99: 279–288.

 

Zhang R, Mirzaei PA, Jones B (2018). Development of a dynamic external CFD and BES coupling framework for application of urban neighbourhoods energy modelling. Building and Environment, 146: 37–49.

 

Zhang K, Chen G, Wang X, et al. (2019). Numerical evaluations of urban design technique to reduce vehicular personal intake fraction in deep street canyons. Science of the Total Environment, 653: 968–994.

Building Simulation
Pages 265-280
Cite this article:
Xiong Y, Chen H. Impacts of uneven surface heating of an ideal street canyon on airflows and indoor ventilation: Numerical study using OpenFOAM coupled with EnergyPlus. Building Simulation, 2022, 15(2): 265-280. https://doi.org/10.1007/s12273-021-0788-5
Metrics & Citations  
Article History
Copyright
Return