AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Powered by AMiner. Clicking this button will take you away from SciOpen.
Home Journal of Advanced Ceramics Article
PDF (1.3 MB)
Cite
EndNote(RIS) BibTeX
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article | Open Access

Effect of Li+ ion mobility on the grain boundary conductivity of Li2TiO3 nanoceramics

Umasankar DASHa( ), Subhanarayan SAHOOb, S. K. S. PARASHARa, Paritosh CHAUDHURIc
School of Applied Sciences, KIIT UniversityBhubaneswar-751 024, India
Department of Electrical and Electronics Engineering, Trident Academy of Technology, Bhubaneswar-751 024, India
Institute for Plasma Research, Bhat, Gandhinagar, Gujurat-382 428, India
Show Author Information

Abstract

Lithium titanate (Li2TiO3) is one of the most promising candidates among the tritium breeding materials because of its good tritium release capacity. Li concentration has much significance on the diffusivity of tritium in the material. The nanocrystalline single-phase Li2TiO3 with monoclinic structure has been prepared by high energy ball milling followed by calcination at 700 ℃ for 2 h. The field emission scanning electron microscopy (FESEM) studies confirmed uniform distribution of nanocrystalline phase with particle size below 100 nm. The study of the Li+ ion diffusion on the sintered sample was investigated by means of electrical conductivity measurements. Electrical properties of the samples were studied in wide temperature (50–500 ℃) and frequency (100 Hz–1 MHz) ranges. The complex impedance spectroscopy (CIS) studies showed the presence of both bulk and grain boundary effects in nanocrystalline Li2TiO3. The bulk resistance of the samples has been observed to decrease with rise in temperature showing a typical negative temperature coefficient of resistance (NTCR) behavior. The low activation energies of the samples suggested the presence of singly ionized oxygen vacancies in the conduction process. The hopping frequency shifted toward higher frequency with increase in temperature. Activation energy of 0.86 eV was calculated from AC conductivity.

Keywords

high energy ball millingAC conductivityimpedance spectroscopynanocrystalline

References

[1]
Alvani C, Casadio S, Contini V, et al. Li2TiO3 pebbles reprocessing, recovery of 6Li as Li2CO3. J Nucl Mater 2002, 307–311: 837–841.
Crossref Google Scholar
[2]
Kopasz JP, Miller JM, Johnson CE. Tritium release from lithium titanate, a low-activation tritium breeding material. J Nucl Mater 1994, 212–215: 927–931.
Crossref Google Scholar
[3]
Roux N, Avon J, Floreancing A, et al. Low-temperature tritium releasing ceramics as potential materials for the ITER breeding blanket. J Nucl Mater 1996, 233–237:1431–1435.
Crossref Google Scholar
[4]
Dienst W, Zimmermann H. Investigation of the mechanical properties of ceramic breeder materials. J Nucl Mater 1988, 155–157: 476–479.
Crossref Google Scholar
[5]
Rasneur B, Charpin J. Chemical properties of lithium ceramics: Reactivity with water and water vapour. J Nucl Mater 1988, 155–157: 461–465.
Crossref Google Scholar
[6]
Hofmann P, Dienst W. Compatibility studies of metallic materials with lithium-based oxides. J Nucl Mater 1988, 155–157: 485–490.
Crossref Google Scholar
[7]
Noda K, Ishii Y, Matsui H, et al. A study of tritium behavior in lithium oxide by ion conductivity measurements. Fusion Eng Des 1989, 8: 329–333.
Crossref Google Scholar
[8]
Roux N, Tanaka S, Johnson C, et al. Ceramic breeder material development. Fusion Eng Des 1998, 41: 31–38.
Crossref Google Scholar
[9]
Gierszewski P. Review of properties of lithium metatitanate. Fusion Eng Des 1998, 39–40: 739–743.
Crossref Google Scholar
[10]
Hegeman JBJ, van Essen EDL, Jong M, et al. Thermomechanical behaviour of ceramic breeder pebble stacks for HICU. Fusion Eng Des 2003, 69: 425–429.
Crossref Google Scholar
[11]
Tsuchiya K, Kawamura H, Takayama T, et al. Control of particle size and density of Li2TiO3 pebbles fabricated by indirect wet processes. J Nucl Mater 2005, 345: 239–244.
Crossref Google Scholar
[12]
Fehr Th, Schmidbauer E. Electrical conductivity of Li2TiO3 ceramics. Solid State Ionics 2007, 178: 35–41.
Crossref Google Scholar
[13]
Kinjyo T, Nishikawa M, Enoeda M, et al. Tritium diffusivity in crystal grain of Li2TiO3 and tritium release behavior under several purge gas conditions. Fusion Eng Des 2008, 83: 580–587.
Crossref Google Scholar
[14]
Wu X, Wen Z, Xu X, et al. Fabrication and improvement of the density of Li2TiO3 pebbles by the optimization of a sol–gel method. J Nucl Mater 2009, 393: 186–191.
Crossref Google Scholar
[15]
Sinha A, Nair SR, Sinha PK. Single step synthesis of Li2TiO3 powder. J Nucl Mater 2010 399: 162–166.
Crossref Google Scholar
[16]
Vittal Rao TV, Bamankar YR, Mukerjee SK, et al. Preparation and characterization of Li2TiO3 pebbles by internal gelation sol–gel process. J Nucl Mater 2012, 426: 102–108.
Crossref Google Scholar
[17]
Ohno H, Konishi S, Nagasaki T, et al. Correlation behavior of lithium and tritium in some solid breeder materials. J Nucl Mater 1985, 133–134: 181–185.
Crossref Google Scholar
[18]
Deptuła A, Łada W, Olczak T, et al. Preparation of lithium titanate by sol–gel method. Nukleonika 2001, 46: 95–100.
Google Scholar
[19]
Tsuchiya K, Kawamura H, Fuchinoue K, et al. Fabrication development and preliminary characterization of Li2TiO3 pebbles by wet process. J Nucl Mater 1998, 258–263: 1985–1990.
Crossref Google Scholar
[20]
Jung C-H. Sintering characterization of Li2TiO3 ceramic breeder powders prepared by the solution combustion synthesis process. J Nucl Mater 2005, 341: 148–152.
Crossref Google Scholar
[21]
Lulewicz JD, Roux N. Fabrication of Li2TiO3 pebbles by the extrusion–spheronisation–sintering process. J Nucl Mater 2002, 307–311: 803–806.
Crossref Google Scholar
[22]
Mandal D, Sathiyamoorthy D, Vinjamur M. Experimental measurement of effective thermal conductivity of packed lithium-titanate pebble bed. Fusion Eng Des 2012, 87: 67–76.
Crossref Google Scholar
[23]
Sinclair DC, West AR. Impedance and modulus spectroscopy of semiconducting BaTiO3 showing positive temperature coefficient of resistance. J Appl Phys 1989, 66: 3850.
Crossref Google Scholar
[24]
Lanfredi S, Rodrigues ACM. Impedance spectroscopy study of the electrical conductivity and dielectric constant of polycrystalline LiNbO3. J Appl Phys 1999, 86: 2215.
Crossref Google Scholar
[25]
Barsoukov E, Macdonald JR. Impedance Spectroscopy: Theory, Experiment, and Applications, 2nd, edn. New York: John Wiley & Sons, 2005.
Crossref
[26]
Wang CC, Wang C, Zeng R, et al. Intergrain connectivity of MgB2 ceramics studied by impedance analysis. J Appl Phys 2010, 108: 023901.
Crossref Google Scholar
[27]
Argall F, Jonscher AK. Dielectric properties of thin films of aluminium oxide and silicon oxide. Thin Solid Films 1968, 2: 185–210.
Crossref Google Scholar
[28]
Vītiņš Ģ, Ķizāne G, Lūsis A, et al. Electrical conductivity studies in the system Li2TiO3–Li1.33Ti1.67O4. J Solid State Electr 2002, 6: 311–319.
Google Scholar
Journal of Advanced Ceramics
Volume 3 Issue 2,
June 2014
Pages 98-108
DOI: 10.1007/s40145-014-0098-9
Cite this article:
DASH U, SAHOO S, PARASHAR SKS, et al. Effect of Li+ ion mobility on the grain boundary conductivity of Li2TiO3 nanoceramics. Journal of Advanced Ceramics, 2014, 3(2): 98-108. https://doi.org/10.1007/s40145-014-0098-9

929

Views

20

Downloads

24

Crossref

N/A

Web of Science

22

Scopus

0

CSCD

Altmetrics
Received: 08 September 2013
Revised: 06 February 2014
Accepted: 19 February 2014
Published: 01 June 2014
© The author(s) 2014

Open Access: This article is distributed under the terms of the Creative Commons Attribution License which permits any use, distribution, and reproduction in any medium, provided the original author(s) and the source are credited.
Return