AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Powered by AMiner. Clicking this button will take you away from SciOpen.
Home Friction Article
PDF (1.8 MB)
Cite
EndNote(RIS) BibTeX
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article | Open Access

Temperature analysis of a pin-on-disc tribology test using experimental and numerical approaches

Oday I. ABDULLAH1,2( ), Josef SCHLATTMANN1
Department of Energy Engineering, College of Engineering, University of Baghdad, Baghdad-Aljadria 47024, Iraq
System Technologies and Mechanical Design Methodology, Hamburg University of Technology, Hamburg 21073, Germany
Show Author Information

Abstract

The high thermal stresses generated at the interface between the contacting surfaces due to the sliding between parts of sliding system such as friction clutches and brakes. In this work, pin-on-disc test rig was built to find the temperature field during the sliding operation using experimental and numerical approaches. In the experimental approach, infrared camera was used to find the temperature distribution, while in the numerical approach a finite element technique has been used. Analysis has been completed using three-dimensional model to simulate a pin-on-disc system. The numerical results have shown a good agreement compared with the experimental results.

Keywords

transient thermal analysispin-on-disc test rigtemperature fieldfrictional heatdry contact

References

[1]
Abdullah O I, Schlattmann J. The effect of disc radius on heat flux and temperature distribution in friction clutches. J Adv Mater Res 505: 154–164 (2012)
Crossref Google Scholar
[2]
Abdullah O I, Akhtar M J, Schlattmann J. Investigation of thermo-elastic behavior of multidisk clutches. J Tribol 137(1): 1–9 (2015)
Crossref Google Scholar
[3]
Abdullah O I, Schlattmann J. Effect of band contact on the temperature distribution for dry friction clutch. J Tribol Ind 35(4): 317–329 (2013)
Crossref Google Scholar
[4]
Abdullah O I, Schlattmann J. The correction factor for rate of energy generated in the friction clutches under uniform pressure condition. J Adv Theor Appl Mech 5(6): 277–290 (2012)
Google Scholar
[5]
Abdullah O I, Schlattmann J. Finite element analysis of temperature field in automotive dry friction clutch. J Tribol Ind 34(4): 206–216 (2012)
Google Scholar
[6]
Abdullah O I, Schlattmann J. An investigation into the thermal behavior of the grooved dry friction clutch. J Tribol 136(3): 1–6 (2014)
Crossref Google Scholar
[7]
Abdullah O I, Schlattmann J. Stresses and deformations analysis of a dry friction clutch system. J Tribol Ind 35(2): 155–162 (2013)
Crossref Google Scholar
[8]
Al-Shabibi A M, Barber J R. Transient solution of the unperturbed thermoelastic contact problem. J Therm Stresses 32(3): 226–243 (2009)
Crossref Google Scholar
[9]
Lee C Y, Sup C I, Chai Y S. Finite element analysis of an automobile clutch system. J Key Eng Mater 353–358: 2707–2711 (2007)
Crossref Google Scholar
[10]
Gao H, Barber G C. Engagement of a rough, lubricated and grooved disk clutch ith a porous deformable paper-based friction material. Tribol Trans 45(4): 464–470 (2002)
Crossref Google Scholar
[11]
Zagrodzki P. Thermoelastic instability in friction clutches and brakes-transient modal analysis revealing mechanisms of excitation of unstable modes. Int J Solids Struct 46(11–12): 2463–2476 (2009)
Crossref Google Scholar
[12]
Shahzamanian M M, Sahari B B, Bayat M, Ismarrubie Z N, Mustapha F. Transient and thermal contact analysis for the elastic behavior of functionally graded brake disks due to mechanical and thermal loads. J Mater Design 31(10): 4655–4665 (2010)
Crossref Google Scholar
[13]
Gao C H, Lin X Z. Transient temperature field analysis of a brake in a non-axisymmetric three dimensional model. J Mater Process Tech 129(1–3): 513–517 (2002)
Crossref Google Scholar
[14]
Ingram M, Noles J, Watts R, Harris S, Spikes H A. Frictional properties of automatic transmission fluids: Part II-origins of friction-sliding speed behavior. Tribol Trans 54(1): 154–167 (2010)
Crossref Google Scholar
[15]
Al-Shabibi A M. Transient behavior of initial perturbation in multidisk clutch system. Tribol Trans 57(6): 1164–1171 (2014)
Crossref Google Scholar
[16]
Wriggers P, Miehe C. Contact constraints within coupled thermomechanical analysis-a finite element model. J Comput Meth Appl Mech Eng 113(3): 301–319 (1994)
Crossref Google Scholar
[17]
ANSYS Inc. ANSYS Contact Technology Guide, ANSYS Release 14.0 Documentation.
[18]
Mohr G A. A contact stiffness matrix for finite element problems involving external elastic restraint. J Comput Struct 12(2): 189–191 (1980)
Crossref Google Scholar
Friction
Volume 4 Issue 2,
June 2016
Pages 135-143
DOI: 10.1007/s40544-016-0110-1
Cite this article:
ABDULLAH OI, SCHLATTMANN J. Temperature analysis of a pin-on-disc tribology test using experimental and numerical approaches. Friction, 2016, 4(2): 135-143. https://doi.org/10.1007/s40544-016-0110-1

723

Views

36

Downloads

35

Crossref

N/A

Web of Science

44

Scopus

3

CSCD

Altmetrics
Received: 14 January 2016
Revised: 28 March 2016
Accepted: 23 April 2016
Published: 16 May 2016
© The author(s) 2016

This article is published with open access at Springerlink.com

Open Access: The articles published in this journal are distributed under the terms of the Creative Commons Attribution 4.0 International License (http:// creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons license, and indicate if changes were made.
Return