AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (1.1 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article | Open Access

Comparison of Nanofibrillated Cellulose and Hydroxyethyl Cellulose in Improving the Storage Stability of Waterborne Coatings

Xinqi Li1,2Jinghuan Chen1,2( )Jingang Liu1,2( )Tao Zhao1,3Kaiji Yang4
China National Pulp and Paper Research Institute Co., Ltd., Beijing, 100102, China
National Engineering Lab for Pulp and Paper, Beijing, 100102, China
Sinolight Specialty Fiber Products Co., Ltd., Langfang, Hebei Province, 065001, China
CNOOC (Tianjin) Oilfield Chemical Co., Ltd., Tianjin, 300450, China
Show Author Information

Abstract

Waterborne coatings often delaminate and settle during long-term storage, requiring the addition of thickeners. The effects of nanofibrillated cellulose (NFC) and the commonly used thickener, hydroxyethyl cellulose (HEC), on the storage stability of waterborne coatings were compared in this study. The morphology of NFC was characterized using infrared spectroscopy (FT-IR) and scanning electron microscopy (SEM). The rotational viscosity and rheological properties of the waterborne coatings with NFC and HEC were tested. Stationary settling experiments were also conducted at different temperatures to compare the difference of NFC and HEC on improving the storage stability of the waterborne coatings. The results showed that the waterborne coating with NFC exhibited pseudoplastic fluid characteristics; a small addition of NFC can achieve the same improvement effect on the storage stability of waterborne coatings as HEC. Further, the improvement effect of NFC was not affected by temperature. The waterborne coating with NFC still exhibited good storage stability at high temperatures, which was significantly superior to that of HEC. Therefore, NFC is a feasible agent for improving the prolonged storage stability and warming-induced delamination of waterborne coatings.

References

[1]

BAO Y, LI X W, XU P. Preparation and Application of Sand-In-Water Multicolor Coatings. Paint & Coatings Industry, 2020, 50(4), 70-75.

[2]

YANG F, HU Z Y, WANG J, CHU H L. A Study on Synthesis and Properties of Sand-in-water Multicolor Coatings. China Coatings, 2020, 35(10), 63-71.

[3]

ZHANG X L, ZHANG H T, CHEN K L, ZHU L T, ZHOU S X. Development and Status of Waterborne Multicolor Stone-like Coatings in China. Paint & Coatings Industry, 2022, 52(10), 71-77.

[4]

LIAN C X, WAN X Y, WANG X, JIANG J L. Influence of Protective Glue on Properties of Sand-in-water Multicolor Coating. Guangzhou Chemical Industry, 2020, 48(14), 79-81.

[5]

LI W. Study on Preparation of Sand-in-Water Multicolor Coatings. Paint & Coatings Industry, 2019, 49(9), 21-25.

[6]

LARSON R G, VANDYK A K, CHATTERJEE T, GINZBURG V V. Associative thickeners for waterborne paints: Structure, characterization, rheology, and modeling. Progress in Polymer Science, 2022, 129, 101546-101557.

[7]

MAESTRO A, GONZÁLEZ C, GUTIÉRREZ J M. Shear thinning and thixotropy of HMHEC and HEC water solutions. Journal of Rheology, 2002,46(6), 1445-1457.

[8]

MAESTRO A, GONZÁLEZ C, GUTIÉRREZ J M. Thickeners for water paints. Ingenieria Quimica, 2005, 37, 117-122.

[9]

KÄSTNER U. The impact of rheological modifiers on water-borne coatings. Colloids and Surfaces A: Physicochemical and Engineering Aspects, 2001,183-185, 805-821.

[10]

ZENG X W, LIU X, WANG C W, ZHANG X Q, YANG H. Effect of cellulose on the morphology of color particles and the effect of stone imitation in sand-in-water multi-color coatings. New Building Materials, 2020, 47(11), 55-59.

[11]
MAI A P. Development of antimildew system of water-based coating -50% antimildew suspension concentrate. Shenzhen: South China University of Technology, 2010.
[12]

EGAMI T, BELLISSARD J. Simple theory of viscosity in liquids. Physical Review E, 2018, 98(6), 63005-63014.

[13]

YANG Z, LI X, SI J, CUI Z, PENG K. Morphological, Mechanical and Thermal Properties of Poly (lactic acid) (PLA)/Cellulose Nanofibrils (CNF) Composites Nanofiber for Tissue Engineering. Journal of Wuhan University of Technology-Mater, 2019, 34(1), 207-215.

[14]

EON J D, ZHANG W, CHEN L, BERRY R M, ZHAO B X. Coating cellulose nanocrystals on polypropylene and its film adhesion and mechanical properties. Cellulose, 2017, 24(4), 1877-1888.

[15]

MEHDI J, JALALUDDIN H, AJI P M, KRISTIINA O. Mechanical properties of cellulose nanofiber (CNF) reinforced polylactic acid (PLA) prepared by twin screw extrusion. Composites Science and Technology, 2010, 70(12), 1742-1747.

[16]

TALEBI H, GHASEMI F A, ASHORI A. The effect of nanocellulose on mechanical and physical properties of chitosan-based biocomposites. Journal of Elastomers & Plastics, 2022, 54(1), 22-41.

[17]

WANG Y F, TACHIBANA S, SEKINE T. A Printed Flexible Humidity Sensor with High Sensitivity and Fast Response Using a Cellulose Nanofiber/Carbon Black Composite. ACS Applied Materials & Interfaces, 2022(4), 14-23.

[18]

LI X Q, CHEN J H, LIU J G, CHEN Q. Preparation and Characterization of Cellulose Nanofibril-Waterborne Polyurethane Composite Films. Paper and Biomaterials, 2023, 8(1), 26-34.

[19]

JI D X, YAN J Q, CHEN J C, LIN Z Y, YANG G H, HE M, JI X X. Effects of High-pressure Homogenization Times on Properties of Eucalyptus Cellulose Nanofibrils. China Pulp & Paper, 2022, 41(10), 8-15.

[20]

WANG H T. Study on Storage Stability of Waterborne Anticorrosive Coatings. Shanghai Coatings, 2020, 58(1), 8-10.

[21]

ZHANG X B, FENG M Q, SUN X H, LI G D, MA X Y. Effects of temperature and concentration on rheological characteristics of sewage sludge. Chinese Journal of Hydrodynamics, 2014, 29(2), 142-149.

[22]

JIRYAEI Z, GHODRATI S, MOHSENI M, GOHARPEY F. A study of rheological properties and storage stability of an acrylic-based paint containing differently organo-modified clays: first International. Conference on Rheology (ICOR), 2019.

[23]

LIU J G, PENG J J, WANG B S, CAO Z L. Effect of CMC on Coating Water Retention Property. China Pulp & Paper, 2002, 33(2), 35-39.

[24]

YAN Y, MEI Y, ZHANG H P. Effects of Thickeners on Viscosity of Emulsion Paint. Materials Reports, 2012, 26(20), 41-45.

[25]

KHAN A A, MUHAMMAD S, ELLAHI R, ZIA Q M Z. Bionic Study of Variable Viscosity on MHD Peristaltic Flow of Pseudoplastic Fluid in an Asymmetric Channel. Journal of Magnetics, 2016, 21(2), 273-280.

[26]

GE L, LI J G. Study on the Influence of Pulping Process on Rheological Properties of Coal Water Slurry. IOP Conference Series: Earth and Environmental Science, 2019, 384, 12107-12115.

[27]

LEI L J, BERTEVAS E L, KHOO B C, THIEN N P. Many-body dissipative particle dynamics (MDPD) simulation of a pseudoplastic yield-stress fluid with surface tension in some flow processes. Journal of Non-Newtonian Fluid Mechanics, 2018, 260, 163-174.

[28]

JIN K Y, TANG Y J, LIU J C, WANG J M, YE C J. Nanofibrillated cellulose as coating agent for food packaging paper. International Journal of Biological Macromolecule, 2021, 168, 331-338.

Paper and Biomaterials
Pages 1-8
Cite this article:
Li X, Chen J, Liu J, et al. Comparison of Nanofibrillated Cellulose and Hydroxyethyl Cellulose in Improving the Storage Stability of Waterborne Coatings. Paper and Biomaterials, 2023, 8(4): 1-8. https://doi.org/10.26599/PBM.2023.9260020

252

Views

24

Downloads

0

Crossref

0

Scopus

Altmetrics

Received: 05 June 2023
Accepted: 18 July 2023
Published: 25 October 2023
© 2023 Published by Paper and Biomaterials Editorial Board.

The articles published in this open access journal are distributed under the terms and conditions of the Creative Commons Attribution 4.0 International License (https://creativecommons.org/licenses/by-nc-nd/4.0/).

Return